These earrings measure 8cm x 2cm
Supplies:
4
head pins (2 for each earring)
4 dark blue pearls
4 eye pins (2 for each earring)
2 dark blue square bead with holes on either sides
2 light blue square beads with holes on either sides
4 light blue pearls 2 earrings hooks
20 guage wire (2 pieces of 4cm each)
Needle nose pliers
Round nose pliers
Wire cutters
4 dark blue pearls
4 eye pins (2 for each earring)
2 dark blue square bead with holes on either sides
2 light blue square beads with holes on either sides
4 light blue pearls 2 earrings hooks
20 guage wire (2 pieces of 4cm each)
Needle nose pliers
Round nose pliers
Wire cutters
Pic 1 |
*Use the round nose pliers to curl both ends inwards and bend it in the middle, using round nose pliers. (make 2 of these)
- Insert the dark blue pearl into a head pin and cut about 1cm, leaving enough to make a loop. use round nose pliers to make a loop.
- Hook this to one of the eye pin then insert one square light blue bead, then light blue pearl and then square dark blue bead as shown in the picture.
- Bend the leftover wire into a loop. Repeat the same procedure for the next hole.
- Insert the ends of curled loop (see pic 1) into the earrings and then attach it with earring hooks.
Repeat these steps to make another earring.
No comments:
Post a Comment